by Fortville Feeders | Jun 22, 2023 | Featured, Tracking Systems
Problem: The manufacturer of auto parts was looking for a new parts feeder solution for an assembly cell. Their engineers had designed the assembly cell with a dead nest to handle four parts, which were assembled and placed on a conveyor. This required the parts to be...
by Fortville Feeders | Jun 28, 2022 | Featured, Hoppers, Tracking Systems
Problem: An integrator needed eight parts-feeding systems that would feed oblong plastic parts at high speeds. The only difference in the machines were the number of lines needed to feed the assembly line. They asked for a traditional vibratory feeder bowl system that...
by Fortville Feeders | Apr 16, 2022 | Escapements and Mechanisms, Featured, Tracking Systems
Problem: An integrator was looking for a new parts feeding system for their robot assembly of bearings. The client had two different bearing parts. One was fully round and the other was a half-round bearing. Both of these bearings were seated in a chamfered retainer...
by Fortville Feeders | Oct 14, 2021 | Featured, Tracking Systems, Uncategorized
Problem: A medical device manufacturer needed to replace an inefficient feeder system for two caps. The system they had attempted to feed two parts from the same vibratory bowl. The two caps had very different geometries. It caused constant jams in their old feeder....
by Fortville Feeders | Aug 2, 2021 | Featured, Tracking Systems
Problem: The manufacturer of plastic containers was in need of an automated feeder system for their closure components. They needed a high-speed system that would handle the molded plastic parts without clogging the machine while supplying their assembly lines at 200...
by Fortville Feeders | May 17, 2021 | Featured, Tracking Systems
Problem: An automated machine builder that specialized in medical syringe assembly and packaging was in need of three identical feeder machines to handle needle holders. The parts were lightweight, very small (1 mm and 3mm widths) and needed to be fed at a rate of 54...
Recent Comments